![]() ![]() Change it to match what you need, such as Air Terminals, or Lighting Fixtures.ģ. Under the Family Properties tab click on Category and Parameters. If you want the new family to cut the face you will be attaching it to in the project, you will need to make a new Void extrusion, make sure it cuts only the face extrusion, and move it into place. They will attach to faces in the nested family. MEP connections do not nest, so after you insert the ceiling based family into the face based family you will need to recreate the MEP connections, and define them properly. You can load the old family into a model, and then using the Component command attache the ceiling based family to the face of the face based family. Rather than painfully reconstructing the family in a new face based model, you can nest the ceiling or wall based family in a new face based model. This limitation has been dealt with somewhat in Revit MEP 2010 in that some families come now as face based such as swithches and receptacles, but the vast majority of availble families are still wall or ceiling based, so what do you do? It has been very frustrating to me that ceiling and wall based MEP families do not attach to linked architectural models. Thu, at 2:20:26 AM | Converting Ceiling Based families to Face Based Families ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |